ST: (0�31) Here you select the step number of the track sequence you want to work on. The individual steps will then be chained together step-wise according to their number. You can have a maximum of 32 steps.
C: (0�127) This is the number of repeats the pattern will execute within the step. The value 1 plays the patter one time. The value 0 (zero) indicates the end of a track sequence. When the drum sequencer gets to this point, it will automatically stop playing.
PT: (1�32) Choose the pattern number to be used in the selected step (ST).
When you press EXIT, the flashing display indicates that you have not yet saved your changes to the track. Press STORE to save your changes in battery-backed-up RAM.
EDIT QS300� Editing the QS300 synthesizer section If you own the AXON AX 100-SB, your AXON is equipped with its own synthesizer, whose sounds can be used like normal presets in your AXON (Instrument group QS300). There are 32 freely programmable voices, which have been preprogrammed by the manufacturer. You can edit them, or create new ones at will. If you would like to keep the factory sounds, you can save them to a computer hard drive or floppy disk via sysex and the appropriate software. You can also write down the parameters so that you can reprogram them later, but this is somewhat tedious because of the number of parameters. Press the ENTER button to get to the program level of the QS300. Note that programming sounds in the QS300 is only possible when the presently selected preset a sound from the QS300 is.
QS300 Voice QS300 Voice number (1�32) Use the +/- Value buttons to select the voice number of the sound you want to edit. There are 32 of them. To the left of the voice number in the bottom half of your display appears the name of the sound that you can change by pressing the ENTER button. To leave text-editor mode, press the EXIT button.
User manual AXON AX-100 / AX-100 SB 55